17

2025

-

09

What to do if the brakes are frozen? Solving the hazard requires just these three tips.


A few days ago, someone posted on a forum saying that their trailer's emergency brake valve was frozen, causing the brakes to lock up, and they were seeking help from fellow truck drivers. "Brothers in the industry, my trailer's emergency brake valve keeps freezing, and the brakes always lock up; please help!" This sparked widespread discussion among truck drivers on the forum. Below, I have summarized some solutions for the issue of the emergency brake valve freezing in winter, hoping to provide some assistance to truck drivers during the winter driving season.

刹车被冻怎么破? 解决隐患只需这三招

● The Working Principle of the Relay ValveThe relay valve is part of the air brake system in vehicles. In the braking system of heavy trucks, the relay valve serves to shorten the response time and the time taken to establish pressure. The inlet of the relay valve connects to the air storage tank, while the outlet connects to the brake air chamber.

刹车被冻怎么破? 解决隐患只需这三招

When the brake pedal is pressed, the output air pressure of the brake valve serves as the control pressure input for the relay valve. Under the action of the control pressure, the intake valve is pushed open, allowing compressed air to flow directly from the air reservoir through the intake port into the brake chamber, instead of passing through the brake valve. This significantly shortens the inflation line of the brake chamber and accelerates the inflation process of the chamber. Therefore, the relay valve is also called the acceleration valve.● What are the reasons that can cause the relay valve to freeze?

刹车被冻怎么破? 解决隐患只需这三招

Under normal circumstances, the reasons for the relay valve being frozen include the following points:1. The coiled heat exchanger is too short. When compressed air enters the air storage tank from the air pump, the temperature cannot drop below 65 degrees Celsius. The high temperature of the compressed air leads to excessive moisture when it encounters cold air, resulting in water accumulation inside the valve body and causing ice formation when temperatures drop below zero, leading to the valve body getting stuck.2. The drying tank has lost its filtering effect on the residual moisture in the compressed air. This causes the compressed air to not achieve the drying purpose, resulting in water accumulation and ice formation inside the pipes and valve body, thus affecting the normal use of brakes.3. The air storage tank is not regularly drained, causing water accumulation inside the tank to enter the valve body with the compressed air. When temperatures are below zero, this leads to ice formation inside the valve body.● Emergency solutions for a frozen relay valve.

 

刹车被冻怎么破? 解决隐患只需这三招

When encountering the situation where the relay valve is frozen, truck drivers often choose methods such as using fire to heat it, pouring hot water on it, or adding alcohol to the air reservoir. However, these are merely temporary solutions and can potentially damage the valve body and pipes if not handled properly. To fundamentally solve the problem, the following methods can be tried:1. Before winter sets in, perform maintenance on the valve body and apply a small amount of petroleum jelly inside the valve body to assist with lubrication of the internal piston.2. Check for accumulated water in the air reservoir and ensure to drain it regularly. If there is too much accumulated water, consider replacing the drying tank.3. Check if the compressed air in the air reservoir can dissipate heat effectively. If the compressed air is too hot, the length of the spiral pipe should be increased.Editorial Note:During winter driving in the north, many issues can arise, and temporary repairs can be quite uncomfortable. As a vital component of the vehicle's braking system, the relay valve must be inspected regularly, and sufficient maintenance should be conducted to prevent problems.