07

2026

-

10

Experienced drivers' tips: brake adjustment and safe driving


A few days ago, a forum member 'Oil Car Driver' posted an article titled 'About Braking and Safe Driving'. From the comments, many valuable car usage tips were discovered, and I've put them together here for everyone to check out.

老司机总结的经验 刹车调节和安全行车 

●  How do you adjust the brakes? Many truck drivers aren't sure how to adjust their brakes. The condition of the brakes directly affects driving safety, so it's best to adjust them yourself if you can. Even if you hire a mechanic, make sure to supervise the whole process.

老司机总结的经验 刹车调节和安全行车 

 

   Due to differences in load capacity across different axles of a vehicle, their functions also vary. Brake adjustments also differ slightly. 'Petrol truck drivers' and 'veterans from Northeast China' say: Generally, brake adjustment involves tightening the adjustment screw on the camshaft lever and then loosening it by three clicks (about 90 degrees), but it is crucial to ensure the brakes on the wheels of the same axle are consistent; different axles bear different loads, so the tightness of adjustments will vary; for the steerable wheels of a truck on slippery roads, it's best to set them a bit loose to avoid sudden lock-ups.

Editor’s Tip:

The above brake adjustment method is only suitable for temporary adjustments on the road. After adjustments, drive for a while to check if the brake drum is overheating. Many tyre fires occur because brake drums were irregular during adjustments and went unnoticed. It's best to jack up the wheels while adjusting brakes, and keep turning the wheels during the process to feel the adjustment.

Brake systems with automatic adjustment levers don't need frequent adjustment, but their reliability and effectiveness should be checked regularly during daily use.

● How to brake

For new drivers, braking might seem as simple as just pressing the brake pedal. In fact, it's not. Let's look at the braking method provided by a 'petrol truck driver': "While driving normally, I press the brake very lightly, mostly short taps (without ABS). Drivers behind me can clearly notice my brake lights flashing rapidly. Experienced drivers behind me will realise the driver ahead is skilled, while new drivers might think the driver is reckless or that there is a problem with the car's wiring. The benefit of short taps is that the tyres don’t lock up – simply put, it’s like a manual ABS."

老司机总结的经验 刹车调节和安全行车 

    Why use the 'pumping' braking method? Firstly, it's a manual version of the ABS anti-lock system, ensuring the vehicle doesn’t lose control on slippery roads; secondly, the tyres don’t slide, achieving maximum braking effect; thirdly, it prevents the brake system from overheating and failing due to prolonged friction; fourthly, it effectively signals vehicles behind you that 'I am braking, be careful', reducing the risk of rear-end collisions.  

Editor's tip:  

Excessive braking can easily cause wheel lock-up. When the brakes lock, the tyres slide against the road (friction can be rolling or sliding; rolling friction generally has a higher coefficient than sliding), reducing braking power and efficiency; also, locked brakes and unchanged contact with the road can cause localised tyre wear. Locking the front wheels removes steering control, making the vehicle uncontrollable. For articulated trucks, front wheel lock-up can easily lead to ‘jackknifing’. Locking the rear wheels can cause the vehicle to skid, and oversteering occurs due to rear wheel lock.  

Some drivers use pumping brakes to prevent wheel lock, but improper operation can quickly drop the air pressure in the reservoir, causing accidents. With truck technology gradually advancing domestically, ABS systems have become standard for most trucks. For safety, it’s advisable to consider this when buying a truck.  

● Driving on the motorway  

1. Engine economical rpm  

Fuel consumption is always a hot topic. On motorways, don’t just chase high speeds and increase the engine rpm without thinking of your wallet. Generally, truck engines perform economically at 1200–1500 rpm; going too high or too low increases fuel consumption.  

2. Safe distance

 

老司机总结的经验 刹车调节和安全行车 

    When driving on the highway, you not only need to maintain a safe distance from the car in front but also constantly check the distance of vehicles behind you using the rear-view mirror. If you notice a vehicle following too closely, you can turn on the hazard lights to alert the driver behind. In bad weather, this distance should be extended accordingly.  Tips:  According to China's Road Traffic Safety Law, when driving on the highway, the safe distance is over 100 metres if the vehicle speed exceeds 100 km/h; if the speed is below 100 km/h, the minimum safe distance should not be less than 50 metres. Traffic authorities explain that at a speed of 60 km/h, the distance should be more than 60 metres; at 80 km/h, the distance should be more than 80 metres, and so on.  Factors affecting braking distance include vehicle speed, driver reaction time, road conditions, weather changes, load weight, and brake structure. Therefore, the faster the speed, the longer the distance travelled during the same reaction time; the smoother the road and the heavier the load, the longer it takes to come to a complete stop, so the safe distance should be appropriately increased.  ● Driving on complex roads  When driving on national roads or routes with complicated surfaces, you need to be more attentive. An experienced driver does it this way:  1. Drive slowly: Most accidents happen because of speeding, which leads to losing control. 2. Look around more: Pay closer attention when passing through towns, especially at the side mirrors. I usually spend about 70% of my driving time checking the mirrors. For taller vehicles, check front, back, and sides as well as whether the vehicle's height can pass, because sometimes vehicles hit power lines or height-restriction bridges. 3. Listen carefully: Open the windows and turn off the music. If something or someone gets caught, there will be noise or calls for help, allowing you to react promptly.

老司机总结的经验 刹车调节和安全行车 

    This truck driver is particularly careful while driving. You can tell from his '70% time spent watching the rearview mirror' and 'opening the window, turning off the music'. Watching the rearview mirror allows you to monitor both sides and the back of the vehicle to avoid hitting pedestrians, while sound is an auxiliary measure based on the previous action.

Editor’s tips:

1. You should use your peripheral vision to check the rearview mirror while ensuring the front is safe. 2. When opening the window, make sure not to disturb resting drivers.

● Postscript:

Good driving habits and regular vehicle maintenance play a crucial role in driving safety. Fellow truck drivers, if you have any good experiences regarding safe driving, feel free to share in the comments.