25

2025

-

10

After the brake pads thin and create a braking gap, how should it be adjusted?


Most of the medium and heavy trucks on the current market use air brakes, and the vast majority use drum brakes, with camshaft-type brakes being the majority among them.

刹车片变薄后产生制动间隙,该如何调整

The braking system accounts for a significant proportion of accidents during long-distance driving. Minor issues can lead to tire blowouts, while severe ones can cause vehicle fires, total vehicle loss, and casualties. Every driver should regularly inspect the braking system, paying particular attention to the brake clearance and the thickness of the brake pads.

刹车片变薄后产生制动间隙,该如何调整

刹车片变薄后产生制动间隙,该如何调整

 

▎Adjustment Method for Camshaft Type Brake Clearance

The following mainly introduces the method for adjusting the clearance of camshaft-type brakes. Its working principle is:

Compressed air enters the brake cylinder, causing the push rod of the brake cylinder to extend outward due to air pressure, which drives the adjustment arm to move. The adjustment arm rotates the camshaft, and the S-cam at the other end of the camshaft pushes the brake shoes outward to make contact with the brake drum, generating braking force, allowing the vehicle to slow down or stop.

After the vehicle has been driven for some time, the brake shoes will gradually wear thinner, causing the brake clearance to increase. If not adjusted in time, when the brake cylinder is fully extended, the brake shoes may not contact the brake drum at all, or even if they do, they will exert no force, resulting in a loss of braking.

刹车片变薄后产生制动间隙,该如何调整

From the diagram, you can see that the key component that can be adjusted here is the part called the adjusting arm. By adjusting it, you can adjust the brake clearance. So, how do you adjust it? 

Many drivers prefer to leave this dirty and seemingly simple task to a mechanic. In fact, adjusting brake clearance really isn't technically difficult, but to ensure your car stays in good condition, you need to pay attention yourself. 

Adjusting arms are divided into manual adjusting arms and automatic adjusting arms, which can be distinguished by a few small characteristics. Manual adjusting arms have been in use for a long time and are very reliable. 

You can adjust the brake clearance through the adjusting nut inside the locking device above: open the observation hole on the dust cover, observe the direction in which the adjusting nut reduces the brake clearance (generally clockwise), stop when there is no gap and the force becomes noticeably stronger, then turn it 180° in the opposite direction, and the adjustment is complete.

刹车片变薄后产生制动间隙,该如何调整

The adjustment method for the self-adjusting arm is the same; however, because there is a self-adjusting mechanism inside, you may hear a 'clicking' sound when tightening the nut. 

Self-adjusting arms generally do not require manual adjustment, but most self-adjusting arms on the market are of concerning quality. Some may lose effectiveness, and in some cases, the brake clearance may become too small or even cause wheel drag. 

At this point, it is necessary to check whether the adjusting arm is functioning properly. You can use a ruler to measure. Adjust the brake clearance as described above, then release the parking brake, press the foot brake and hold it. Another person should measure the extension length of the brake cylinder push rod. The extension lengths on both sides should be the same or nearly the same. If there is an abnormality on one side, it requires special attention.