22
2026
-
08
Introduction to conventional brake valves Basic knowledge of emergency relay valves
The performance and quality of the valve body on a truck have a direct impact on the vehicle's braking performance, with different valve components playing their respective roles. But many people may not fully understand the role of each valve on a truck. Here's some information from 'jiangtj6760' about the emergency relay valve, organised and shared with everyone.
The emergency relay valve, also known as the three-axle synchronising valve, is installed on semi-trailers. Currently, many trailers only have this one valve in the air system.
Currently, there are two main types of relay valves: WABCO and Haldex. As for the specific connections, WABCO specifies port 1 as the air supply port, connected to the red spiral hose; port 2 connects to the ABS valve and has no air pressure; port 4 is the control port, connected to the yellow spiral hose, also without air pressure; ports 1-2 connect to the trailer air tank and normally have air; port 3 is the exhaust valve. Haldex labels port 1 as ENERGY, port 2 as DELIVERY, port 4 as SERVICE, and ports 1-2 as RESERVOIR.
The emergency relay valve is used to control the trailer service brake. If the air supply line breaks, the action of the emergency relay valve will cause the trailer to automatically brake. While driving: port 1 usually has air, port 4 has no air; when braking: port 4 is pressurised, the piston moves down, and the air pressure from 1-2 passes through port 2 to the ABS valve, causing the brake calipers to work. When parked: port 4 is pressurised, the piston moves down, and the air pressure from 1-2 passes through port 2 to the ABS valve, causing the brake calipers to work, the same as when braking. When the air pressure in the reservoir leaks to a certain level, the spring in the spring chamber automatically extends to act as a parking brake. If the spiral air pipe accidentally breaks: ports 1 and 4 have no air pressure, and the air pressure from port 1-2 passes through port 2 to apply the brakes automatically. The national standard (GB12767—1999) also has regulations regarding the emergency relay valve. If one of the supply lines (or other possible connections) breaks or leaks, the driver must be able to use the service brake, emergency brake, or parking brake control devices to apply the trailer brakes fully or partially.
Above is the air pressure curve during vehicle braking, the output pressure at vent 2 rises linearly with the pressure at control port 4.
The above picture shows the air pressure curve when one port (red spiral tube) leaks. When the pressure at inlet 1 (red spiral tube) drops to around 2.5 kg, outlet 2 begins to fill to the same pressure as the air reservoir, which means the trailer will automatically brake when the red spiral tube breaks.
● Editor's note:
Thanks to introductions from friends on the forum, I believe everyone now has a certain understanding of the emergency relay valve and its working characteristics. In daily truck life, it's not enough just to know how to drive; you should also learn more about truck-related knowledge. Hopefully, there will be more good articles like this to help everyone learn and improve.




